User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd. -
101 -
z ospf cost <cost-value>
An optional command to statically set OSPF cost value for the manager.
z ospf auth-type { simple/md5 }
An optional command to use authentication when the interface and the
router in the area where the interface belongs exchange routing
information. The manager shall set the authentication method – the
simple text method or MD5 encryption method.
z ospf auth-key <key-string>
Sets key value for authenticating routing information exchange between
the interface and the neighboring router. (This key value must be set
when authentication is used, and it must be the same with the key value of
the router in the same area.)
z ospf auth-id <key-id>
Sets key identifier for authenticating routing information exchange
between the interface and the neighboring router. (This key identifier must
be set when authentication is used, and it must be the same with the key
identifier of the neighboring router.)
z ospf priority <priority-value>
1. Decides the priority to become DR when the OSPF select
DR/BDR/Drouter between the interface and the neighboring router.
The priority range is 1 ~ 255. The higher the value is, the higher the
priority is.
2. The default is 1.
z ospf hello-interval <interval-time>
1. Sets the hello interval that the router exchanges with a neighboring
router through the interface to configure the adjacency. The hello
interval shall be the same with the hello interval of the neighboring
router.
2. The default is ten seconds. However, the default is 30 seconds in the
frame-relay network.