Installation guide

AP-IP200 IP Phone Installation Guide (Release 1.00E) Aug. 2005
AddPac Technology Proprietary & Documentation 93 - 80
[UTP Cable (RJ-45 to RJ-45) Pinout Specification]
In order to connect the LAN port of this equipment with other equipments (i.e. HUB), the RJ-
45 to RJ-45 Ethernet Cable is used. The RJ-45 Connector Pin sequence is provided below
and the signal and Pinout specifications are enlisted at the below table.
Figure 6-1 100Base-TX RJ-45 Connector
[Table 6-2] Signal and Pinout of Direct Ethernet Cable
RJ-45 Signal Direction RJ-45 PIN
1
Tx + →
1
2
Tx - →
2
3
Rx + ←
3
4
- -
4
5
- -
5
6
Rx - ←
6
7
- -
7
8
- -
8
1. These specifications are for ethernet direct cables connecting this equipment and
HUB.
2. For IP Phone to IP Phone or IP Phone to PC connection, the Cross Cable must be
used.