User guide

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/
10-14. Copy with Size
Causes duplicate drive to report to an operating system the exact same
total size as source when copy is complete. Works only on drives format-
ted using a Master Boot Record. Default setting is OFF.
Advanced Setup Options
12-01. Read Error Skip
Allows duplicator to ignore I/O errors while reading source drive. Default
setting is OFF.
12-02. Update Firmware
Used to apply firmware updates. Connect a drive formatted as FAT
containing one partition with the firmware file in the root directory.
NOTE: This function scans the entire disk before proceeding. Providing a
drive that is as small as possible is strongly recommended.
12-03. Compare Firmware
Used to confirm correct firmware. Connect a drive formatted as FAT
containing one partition with the firmware file in the root directory.
NOTE: This function scans the entire disk before proceeding. Providing a
drive that is as small as possible is strongly recommended.
12-04. Quick Erase HDD
Scans the ports, then quickly erases all sectors on all connected drives.
12-05. Full Erase HDD
Scans the ports, then completely erases all sectors on all connected
drives.
12-06. H/W Diagnostic
Starts comprehensive tests for Ram, LCD, buttons, ports and Flash.
12-07. Load Default
Resets all configuration settings to default.
12-08. Copy HPA
Enables copy functions to duplicate the source drive's Host Protected
Area. Normally this area is defined as not available to a host controller as
defined by ATA/SATA specifications.