User guide

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/
9. Overwrite
Overwrite is used to write data onto the entire hard disk, it will destroy all
data on all HDDs connected to the duplicator (including Source HDD) by
writing data to all sectors. There are 4 sub-options: One pass (zero), One
pass (random), 3 pass and 7 pass.
10. Setup
Enters the Setup menu. See Setup Options.
11. View Log
Shows the results from the most recent drive operation, such as copy,
overwrite, etc.
12. Adv Setup
Enters the Advanced Setup Menu. Only available by holding ESC on any
Main Menu option. See Advanced Setup Options.
Setup options
10-1. Language
Use this option to select the language of the system, currently only
English is supported.
10-2. Copy Size
Controls how much of the source drive to use for copy operations, in
percentage. Default setting is ALL (100%).
10-3. Startup Menu
Sets the first menu option to appear after boot. Default setting is Copy
HDD.
10-4. Auto Compare
Controls whether or not targets are compared automatically when copy is
complete. Default setting is OFF.
10-5. Button Sound
Enables audible beep when pressing buttons. Default setting is ON.
10-6. Device Info
Displays information about connected drives. Main display is drive
manufacturer and size. Press up/down to select drives, ENT to display
model number and firmware revision of selected drive.