T E C H N O L O G I E S User Guide 1:5 2.5" HDD/SSD Duplicator HD525LTHS www.addonics.com Technical Support If you need any assistance to get your unit functioning properly, please have your product information ready and contact Addonics Technical Support at: Hours: 8:30 am - 6:00 pm PST Phone: 408-453-6212 Email: http://www.addonics.
Drive Installation The SOURCE drive is the top unit, the TARGET drives are the remaining units below. 1. Move the silver button slightly to the right to open the door. 2. Insert the drive with the SATA connector toward the rear with label side on top. The drive should slide in easily, don't force it. 3. Close the door on the drive bay. It should also give little resistance, don't force it. As soon as the drive is in position it will power up. www.addonics.
Connecting the Power Cable and Powering On a.Connect the power cord provided from the wall outlet to the back of the tower. b. Turn on the main power switch on the rear of the chassis. c. Push the power button on the front of the unit to turn on the HDD duplicator. The Duplicator Panel There are four buttons and an LCD on the panel of HDD Duplicator. 1 – LCD shows a function or a message. Duplicator Panel 2 – it is used to scroll up function menus. 3 – it is used to scroll down function menus.
Main Menu 1. Copy HDD Scans the ports, then copies from the source to any targets found. 2. Async Copy HDD Scans the ports, then copies from the source to any targets found. More drives may be added before the process is complete, they will begin the process as soon as they are detected. 3. Compare HDD Scans the ports, then any targets found will be compared to the source. 4. Async Compare Scans the ports, then any targets found will be compared to the source.
9. Overwrite Overwrite is used to write data onto the entire hard disk, it will destroy all data on all HDDs connected to the duplicator (including Source HDD) by writing data to all sectors. There are 4 sub-options: One pass (zero), One pass (random), 3 pass and 7 pass. 10. Setup Enters the Setup menu. See Setup Options. 11. View Log Shows the results from the most recent drive operation, such as copy, overwrite, etc. 12. Adv Setup Enters the Advanced Setup Menu.
10-7. System Info Displays firmware version and date. 10-8. Fast Copy When this setting is ON, the duplicator will attempt to copy the source drive's contents instead of the entire disk. Also controls Compare function. Default setting is OFF. NOTE: Target drive size is still required to be equal to or greater than source. Only works with source drives formatted using Master Boot Record. If the source drive has a boot record other than MBR, the entire disk will be copied as if Fast Copy were OFF.
10-14. Copy with Size Causes duplicate drive to report to an operating system the exact same total size as source when copy is complete. Works only on drives formatted using a Master Boot Record. Default setting is OFF. Advanced Setup Options 12-01. Read Error Skip Allows duplicator to ignore I/O errors while reading source drive. Default setting is OFF. 12-02. Update Firmware Used to apply firmware updates.
12-09. Burn In Runs a function continuously until aborted. Selections are Copy & Compare, Compare, Async Cpy & Cmp, Async Compare. CONTACT US www.addonics.com Phone: Fax: Email: 408-573-8580 408-573-8588 http://www.addonics.
