User`s guide

8.3 Startup Menu
This option allows you to set an option other than "Setup" to be displayed as the
first available option on the menu every time you start the system.
Press ENT then use the Up and Down arrow keys to choose other options. By
default the first menu option is Copy HDD.
8.4 Auto Compare
This option automatically compares the source hard disk with the target hard disk
after a copy operation is completed.
Press ENT to access option. By default it is set to Off. Use the Up and Down
arrow keys to choose On.
8.5 Button Sound
Press ENT and the LCD will display the following info. Use the Up and Down
arrow keys to choose whether button sound is on or off.
8.6 Device Info
This option is used to display the details of all hard disks connected to the copy
controller.
Press ENT and the LCD will display each hard disk' information in order as
shown below.
8.7 System Info
This option displays system information.
8.8 Fast Copy
This option displays Fast Copy. Fast Copy only copies data on the source drive
to the target drives.
Press ENT and the LCD will display the following info. Use the Up and Down
arrow keys to choose whether fast copy is on or off. (This function currently only
supported in FAT, FAT32, NTFS, HFS, Ext2 and Ext3 partitions.)
8.9 Auto Start Drive
This option is used to copy automatically once you inserted a HDD on target port.
Press ENT to enter the following figure. The default is OFF. Use the Up and
Down arrow keys to choose 1-5.
8.10 Auto Start Timer
This option is used to set the period of time when the duplicator starts copying
automatically once you insert HDD on target port.
Press ENT to enter the following figure. The default is OFF. Use the Up and
Down arrow keys to choose 5 Sec-50 Sec.
8.11 Tolerance Size
This option is used to set the tolerance in terms of percentage the difference in
the source and target capacity. This is to ensure that when the target drive is
smaller than the source drive, the duplication process will not start.
Press ENT to enter the following figure. The default is Off. Use the Up and Down
arrow keys to choose 1%~100% of source.