User`s guide

4 Async Compare

Compare HDD is used to see if the data on a source hard disk is identical to the

target hard disk after the Copy HDD operation. While compare process is on-

going, allows you to plug-in additional target drives and comparison will

automatically start for the added target drive.

Choose option 4 from the menu:

Press ENT to begin the comparison. The LCD will display the following info

Once the comparison is complete the LCD will display the following info as well

as the amount of data on the source hard disk.

5 PreScan HDD

PreScan HDD is used to check if the source hard disk can be accessed properly.

It also tests the read speed.

Choose option 5 from the menu:

Press ENT to begin scan. The LCD will display the following info

Once the scan is complete, the LCD will display the corresponding results

6 ReScan Bus

Choose option 6 from the menu:

Press ENT to re-scan hardware. The LCD will display the following info.

Press ENT to begin scanning IDEO0:Master/Save ~ IDE1:Master/Slave.

When the scan is complete the LCD will display the following info.

7 Source HDD Size

Source HDD Size is used to show the capacity of the source hard disk.

Choose option 7 from the menu:

Press ENT and the LCD will show the following info.

8 Set up

Setup allows various system settings to be changed. There are 8 sub-options:

Language, Copy Size, Startup Menu, Auto Compare, Copy with detect, Button

Sound, Device Info and System Info.

Choose option 8 from the menu:

8.1 Language

This option is used to select the system's language support. By default this is set

to English. Press ENT to change the Language settings.

8.2 Copy Size

This option is used to specify the size of the source hard disk for simplifying

further copying operations.

Press ENT and the LCD will display a detailed list of options as shown below

Use the Up and Down arrow keys to choose different copy sizes. The system will

offer their corresponding percentages so the user can specify the amount to copy

from the source hard disk.

Press ENT to confirm and save the changes.