User manual

Figure 4.4.1.1
(Figure 4.4.1.1: This is Snap VD, but it is not exported.)
7. Move cursor to the gray button next to the Snapshot V D number; click
“Export”. Enter a capacity for snapshot VD. If size is zero, the
exported snapshot VD will be read only. Otherwise, the exported
snapshot VD can be read/written, and the size will be the maximum
capacity to read/write.
8. Attach a LUN for snap shot VD. Please refer to the previous chapter for
attaching a LUN.
9. Done. It can be used as a disk.
Figure 4.4.1.2
(Figure 4.4.1.2: This is the list of “VD-01”. There are two snapshots in “VD-01”. Snapshot
VD “SnapVD-01” is exported to read only, “SnapVD-02” is exported to read/write.)
10. There are two methods to clean all snapshots. In “/ Volume
configuration / Virtual disk”, move cursor to the gray button next to
the VD number; click “Cleanup snapshot ”. Or in “/ Volume
configuration / Snapshot”, click “ ”.
11. Cleanup will delete all snapshots related to the VD and release
snapshot space.
Formatted
Formatted