User manual

3.8.2 Upgrade
“Upgrade” allow you to upgrade the firmware. Prepare new firmware file named
“xxxx.bin” in local hard drive, then click “ ” to select the file. Click
“ ”, it will pop up a message “Upgrade system now? If you
want to downgrade to the previous FW later (not recommend), export your
system configuration in advance”, click “Cancel” to export system co nfiguration
in advance, then click “OK” to start to upgrade firmware.
Figure 3.8.2.1
Figure 3.8.2.2
When upgrading, there is a progress bar running. After upgrade is completed, the
system must be manually rebooted to make the new firmware take effec t.
3.8.3 Reset to factory default
“Reset to factory default” allows user to reset controller to factory default
setting.
Figure 3.8.3.1
Reset to default value, the password is: supervisor, and IP address to default
DHCP.
Examples:
Default IP address: 192.168.10.50 (DHCP)
Default subnet mask: 255.255.255.0
Formatted
Formatted