User manual

3.6.7 Example
The following is an example for creating volumes. Example 1 is to create two
VDs and set a global spare disk.
• Example 1
Example 1 is to create two VDs in one RG, each VD uses global cache volume.
Global cache volume is created after system boots up automatically. So, no
action is needed to set CV. Then set a global spare disk. Eventually, delete all of
them.
Step 1: Create RG (RAID group).
To create the RAID group, follow the steps below:
Figure 3.6.7.1
1. Select “/ Volume config uration / RAID group” .
2. Click “ “.
3. Input a RG Name, choose a RAID level from the list, click
“ “ to choose the RAID PD slot (s), then click
“ “.
4. Check the outcome. Click “ “ if all setups are
correct.
5. Done. A RG has been created.
Formatted