User manual

G. Installation Steps for Large Volume (TB)
Introduction:
The ISC8P2G-S is capable of support ing large volumes (>2TB). When
connecting controllers to 64bit OS installed host/server, the host/server is
inherently capable for large v olumes from the 64bit address. On the other side, if
the host/server is installed with 32bit OS, user has to change the block size to
1KB, 2KB or 4KB to support volumes up to 4TB, 8TB or 16TB, for the 32bit
host/server is not LBA (Logical Block Addressing ) 64-bit supported. For detailed
installation steps, check below.
Step A: configure your target
1. Go to / Volume config / Volume group , create a VG.
Figure H.1
2. Choose RAID level an d disks.
Figure H.2
3. Confirm VG settings.
Figure H.3