User manual

The MC/S setup instructions is very similar to MPIO. Detailed steps are
presented below. For the target side setting, the steps are exactly the same as
MPIO. Please refer to Figure F.1 to Figure F.8 .
1. Create a VG with RAID 5, using 3 HDDs.
2. Create a UDV by using RAID 5 VG.
3. Run Microsoft iSCSI initiator 2.0 8 and check the Initiator Node Name.
4. Attach LUN to R5 UDV. Input the Initiator Node Name in Host field.
5. The volume config setting is done.
6. Check iSCSI settings. The IP addr ess of iSCSI data port 1 is
192.168.1.112 and port 2 is 192.168.1. 113 for example.
7. Add Target Portals on Microsoft iSCSI initiator 2.03.
8. Input the IP address of iSCSI data port 1 (192.168.1. 112 as mentioned
in previous page s). For MC/S, there is only ONE “Target Portal” in the
“Discovery” tab.
Figure F.1