User guide

139 | P a g e
2 - Create a bootable CP/M diskette by first FORMATting the blank diskette, and then SYSGEN it,
being certain that the BIOS.SYS is on the disk. You can simply run MOVCPMxx from the
distribution disk, and then run SYSGEN, hitting RETURN for the source drive name. If in doubt,
refer to your Heath/Zenith CP/M documentation for details on the use of FORMAT, MOVCPM, and
SYSGEN. This disk will be referred to as the "QSBIOS system disk" throughout the remainder of this
document. You may want to put PIP.COM on the disk until all files are PIPped over. Then in the case
of an H17 disk, ERAse PIP.COM to get enough space to carry out the procedures.
Now BOOT off the QSBIOS SYSTEM DISK.
NOTE: Depending on the version of CP/M you are using, you will use the appropriate INSTLxx.SUB file.
Be sure to use the proper file or the end results will be disastrous!
IF YOU ARE USING CP/M 2.2.03:
INSTL03.SUB must be used in the following step.
IF YOU ARE USING C P/M 2.2.04:
INSTL04.SUB must be used in the following step.
3 - Using PIP, copy the following files from your QSBIOS Distribution Disk(s) onto your QSBIOS system
disk:
QSPUTSYS.GEN EX14.COM INSTLOx.SUB CFGPATCH.COM
In addition, IF YOU WANT ZCPR to be automatically installed, include the following two files. If not,
do not copy them on the disk.
ZCPR.COD ZCPR.REL
4 - Using PIP, or any other suitable means, copy the following files from your Heath/Zenith CP/M
Distribution Disk(s) onto your QSBIOS system disk:
DDT.COM MOVCPM17.COM CONFIGUR.COM
5 - Run the installation program on your QSBIOS system disk by typing:
EX14 INSTLOx, where x is 3 or 4, depending on your CP/M version.
When completed, QSPUTSYS.GEN, MOVCPM17.COM, CFGPATCH.COM, CONFIGUR.COM,