Addonics T E C H N O L O G I E S Diamond Combo Hard Drive DCHDSAES & DCHDIES DCHDIEU & DCHDSAEU User’s Guide Version 1.
FCC Warning Statement This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
For IDE Drive Note: Set up your IDE hard drive as Master device Cable Connections Connect the 4-Pin Molex cable to the power connector on the IDE hard drive. Carefully place the IDE hard drive with the label facing up into the Diamond enclosure. Push the hard drive towards the back end to secure the drive connectors onto the Diamond enclosure’s IDE connector. Mini-Din power connector Step 4 Turn the Diamond enclosure over with the hard drive mounting holes facing up.
Cable Connections When Used as an Internal Hard Drive Technical Support Power: Use either the 4-pin Molex or the 15-pin SATA power connector. Do not use both power sources simultaneously. If you need assistance to get your unit functioning properly, please call Addonics Technical Support. Our technical staff will be happy to assist you, but they will need your help to do so. Calling the technical support staff without all the proper information can be both time consuming and frustrating.
