User guide

Addonics Technologies 4
Chapter 1 Hardware Installation
Enclosure Overview
Step 1
Loosen the two screws from the rear panel. Pull out the interior tray from the
enclosure.
Step 2
For Model: AE5IDECSU2 (For IDE hard drive installation)
Note: You need to configure your IDE hard drive as MASTER before using it
with the enclosure. If you are not sure how to configure your hard drive as a
MASTER device, contact your hard drive manufacturer.
Connect the 4-pin Molex power
cable to the power connector of
the hard drive.
Also connect the 40-pin IDE
ribbon cable (MASTER DEVICE
0) to IDE connector of the hard
drive.
Screw 1
Screw 2
Power
Connector
Switch
Firewire
Connections
Fan USB Port
4-pin Molex
power cable
40-pin IDE
ribbon cable