Specifications

SATA-IO Confidential 28
• If the above is false, then the test is not applicable
• Otherwise, run the following test
o Check value of Word 85 bit 7
o Issue SET FEATURES to alter setting for release interrupt enable/disable
o Issue COMRESET and complete OOB sequence
o Check value of Word 85 bit 7
• Verify that IDENTIFY DEVICE or IDENTIFY PACKET DEVICE Word 85 bit 7 contains the same value
following COMRESET
Pass/Fail Criteria
2.4.10. SSP-10 : Set Features – Service Interrupt
2.4.10.1. Device Expected Behavior
NOTE - To test the following requirement, a device must claim support for service interrupt (Word 82 bit 8 set to one
in IDENTIFY DEVICE or IDENTIFY PACKET DEVICE data).
Upon receipt of a COMRESET, a device shall maintain the value of service interrupt enable/disable. Specifically, if
support for service interrupt is enabled (Word 85 bit 8 set to one in IDENTIFY DEVICE or IDENTIFY PACKET
DEVICE data) upon receipt of a COMRESET then the feature shall be enabled after the COMRESET. If support for
service interrupt is disabled (Word 85 bit 8 cleared to zero in IDENTIFY DEVICE or IDENTIFY PACKET DEVICE
data) upon receipt of a COMRESET then the feature shall be disabled after the COMRESET.
• Check Word 78 bit 6 in IDENTIFY DEVICE or IDENTIFY PACKET DEVICE (set to one)
Measurement Requirements
• Check Word 82 bit 8 (set to one)
• If the above is false, then the test is not applicable
• Otherwise, run the following test
o Check value of Word 85 bit 8
o Issue SET FEATURES to alter setting for service interrupt enable/disable
o Issue COMRESET and complete OOB sequence
o Check value of Word 85 bit 8
• Verify that IDENTIFY DEVICE or IDENTIFY PACKET DEVICE Word 85 bit 8 contains the same value
following COMRESET
Pass/Fail Criteria
2.4.11. SSP-11 : Set Multiple Mode
2.4.11.1. Device Expected Behavior
This test is not applicable to ATAPI devices.
NOTE - To test the following requirement, a device must claim that the multiple sector setting is valid (Word 59 bit 8
set to one in IDENTIFY DEVICE data).
Upon receipt of a COMRESET, a device shall maintain the block size established by the Set Multiple Mode command.
Specifically, the value contained within Word 59 bits 8:0 in IDENTIFY DEVICE data shall be maintained after a
COMRESET.
• Check Word 78 bit 6 in IDENTIFY DEVICE (set to one)
Measurement Requirements
• Check Word 59 bit 8 (set to one)
• If the above is false, then the test is not applicable
• Otherwise, run the following test