User manual

NHP5010 User Manual
79
In this page, you may configure the priority of the LAN interfaces, incoming and
outgoing rate limits, and flow control.
The following table describes parameters in this page:
Field
Description
Port
The PLC wireless router supports 2 LAN interfaces
and 4 WLAN interfaces.
Priority
You can select LOW or HIGH.
Flow Control
Enable or disable the flow control.
Incoming Rate Limit
Set the incoming rate limit. Full indicates that there is
no limit to the incoming rate.
Outgoing Rate Limit
Set the outgoing rate limit. Full indicates that there is
no limit to the outgoing rate.
After setting the parameters, click Apply to save the settings.
5.3.4.4 Static Routing
Static routing is a special routing type. Applying proper static routing rules on a
network can reduce the routing problems, improve the overload of routing traffic,
and increase the forwarding speed of data packets. You can set the destination IP
address, subnet mask, and gateway to specify a routing rule. The destination IP
address and subnet mask are used to determine a destination network or a host.