User manual

NHP5010 User Manual
53
In this page, you can configure the LAN settings of the PLC wireless router. You
can modify the IP address of the LAN interface according to the actual network
environment. The default IP address is 192.168.99.1. Please note that this is an
optional operation. Usually, you need not to modify the default settings in this page.
You may use the default settings and DHCP service to manage the IP setting of
the private network. The IP address of your host is from the DHCP address pool. If
you want to enable the DHCP function of the PLC wireless router on the LAN, the
network segment of DHCP IP pool of PLC wireless router must be the same as
that of the IP address of your host. If the IP network segment of the PLC wireless
router changes, the network segment of the DHCP IP pool will also change
automatically.
The following table describes parameters in this page:
Field
Description
Router IP Address
Set the IP address that a LAN user uses to access the
router. The default IP is 192.168.99.1. You can change it if
necessary.
Subnet Mask
Subnet mask of the LAN interface. You can enter a different
subnet mask according to the actual network environment.
Enable Gateway
Isolate
After the gateway isolation is enabled, PCs on the LAN side
cannot communicate with each other directly among
different gateways.
Enable DHCP
Server
Enable or disable the DHCP server.
IP Pool Starting
Address
The first address in a consecutive IP address pool.
IP Pool Ending
Address
The last address in a consecutive IP address pool.
IP Pool Subnet
Mask
The subnet mask of the IP pool is the same as that of the
PLC wireless router.
DHCP Lease Time
After the DHCP lease time is over, the PLC wireless router
automatically assigns new IP addresses for all connected
computers.
Domain Name
Server Assignment
You can manually enter the IP address of domain name
server or let the DNS server automatically assign one to