User manual

NHP5010 User Manual
50
SSID, security mode, and password. To use this function, a wireless client must
support WPS. If the wireless client does not support WPS, you must manually
configure the wireless settings of wireless client, and ensure that its SSID and
other wireless security settings are the same as that of the PLC wireless router.
Choose Wirelss Setup > WPS on the left pane or click WPS in the WIRELESS
SETUP page to display the following page.
The following table describes parameters in this page:
Field
Description
Wireless SSID
Select a wireless SSID from the drop-down list.
WPA Mode
Display current WPA mode.
Enabled WPS
Enable or disable WPS.
Push Button
Click the PBC button in this page, and then click
the PBC button in the configuration utility page of
wireless network card or press the WPS
pushbutton on the wireless network card within 2
minutes to finish WPS configuration.
Input Station PIN
Enter the PIN code that is generated randomly by
the configuration utility of wireless card.
WPS Session Status
Display current WPS connection status.