User manual

NHP5010 User Manual
43
The following table describes parameters in this page:
Field
Description
Enable Wireless
Interface
Enable or disable the wireless interface.
Wireless Network
Name (SSID)
The wireless network name (SSID) can contain up to 32
characters and can be letters, numerals, underlines, and any
combinations of them. The SSID is case-sensitive.
Visibility Status
If Visible is selected, the PLC wireless router
broadcasts its SSID on the wireless network.
If Invisible is selected, the PLC wireless router does not
broadcast its SSID on the wireless network.
Country
Select the country where you are from the drop-down list.
802.11 Mode
Select the appropriate wireless mode. The default is Mixed
802.11b/g/n.
802.11b only: The maximum rate is 11Mbps.
802.11g only: The maximum rate is 54Mbps.
802.11n only: For 20M bandwidth, the maximum rate is
130Mbps (150Mbps for short preamble); for 40M Upper
(+) or 40M Lower (-) bandwidth, the maximum rate is
270Mbps (300Mbps for short preamble).
Mixed 802.11b/g: It is compatible with 802.11b and
802.11g.
Mixed 802.11n/g: It is compatible with 802.11n and
802.11g.
Mixed 802.11b/g/n: It is compatible with 802.11b,
802.11n, and 802.11g.
Band Width
Only in the 802.11 mode that is compatible with 802.11n, can
you set the band width. For 20M bandwidth, the maximum
rate is 130Mbps (150Mbps for short preamble); for 40M
Upper (+) or 40M Lower (-) bandwidth, the maximum rate is
270Mbps (300Mbps for short preamble).
Wireless Channel
Select the working channel of the wireless network. The
default is Auto Scan, which indicates that the PLC wireless
router automatically searches for the best channel among
the available channels.