Install guide

For any further information on ADDON product, please visit our website: http://www.addon-tech.com 5
b) Setup Wireless Security Key by using WPS button
WPS refers to Wi-Fi Protected Setup. You can use the WPS Pushbutton to add a
wireless client to a network, without setting some specific parameters, such as SSID,
security mode, and password.
To use this function, a wireless client (for example your PC, Laptop, Smartphone, Tablet,
etc.) must support WPS. If the wireless client does not support WPS, you must manually
configure the wireless settings of wireless client (page 6 to 10)
Just follow these two steps:
1) Press the WPS button on the NHP5010 for less than 3 seconds
2) Press the WPS button on the network card or click the PBC button in the
configuration utility page of network card/adapter within two minutes to
start WPS connection.
You can connect many devices to the same NHP5010 by using WPS button (just repeat
the 2 steps above)
As soon as you press the WPS button on the NHP5010, the WLAN/WPS light will turn to
orange and will start to flash for about 2 minutes.
If your wireless connection ADDON NHP5010 is unprotected by password, when you
press the WPS button on the NHP5010, the name of your wireless connection (SSID)
will change from ADDON-NHP5010 to Network-abcdef123456 (where abcdef123456 is
a 12 digit variable combinations of letters and numbers that correspond to the MAC
address of your device) and a password will be generated randomly.
If you want to customize SSID and password, you need to login to the management
page (page 6 to 10).
If your device supports WPS and run Windows 7 or 8, you can follow this guide at this
link: www.addon-tech.com/WPSNHP5010.pdf
Note: If you press the WPS button on the NHP5010 for more than 5 seconds, you can
enable or disable the WLAN.