Install guide

For any further information on ADDON product, please visit our website: http://www.addon-tech.com 14
3. IMPORTANT: Go back to Internet Protocol Version 4 (TCP/IPv4) Properties
(check b) Login to the management page from point 1. To point 6.)
and select Obtain an IP address automatically and Use DNS server
address automatically and then click OK.
4. Your wireless connection will be disconnected automatically if you are using
the wireless connection when you setup the wireless security. Please wait for
a few seconds and reconnect to it by entering your network key. Make sure
HP5100 is connected to the router before reconnecting the PC or laptop to
NHP5010 by wireless.
5. If you cannot access the Internet after reconnecting to wireless Homeplug,
then turn off NHP5010 and turn it on again.
6. Connect your PC or laptop to NHP5010 again. You should be able to access
the Internet.