Install guide

For any further information on ADDON product, please visit our website: http://www.addon-tech.com

i) Use of the WPS Pushbutton

WPS refers to Wi-Fi Protected Setup. You can use the WPS Pushbutton to add a

wireless client to a network, without setting some specific parameters, such as SSID,

security mode, and password.

To use this function, a wireless client (for example your PC or Laptop) must support

WPS. If the wireless client does not support WPS, you must manually configure the

wireless settings of wireless client.

Just follow these two steps:

1) Press the WPS button on the NHP5010 for less than 3 seconds

2) Press the WPS button on the network card or click the PBC button in the

configuration utility page of network card within two minutes to start WPS

connection.

Note: If you press the WPS button on the NHP5010 for more than 5 seconds, you can

enable or disable the WLAN.

j) Reset the NHP5010

If you want to restore the system for the NHP5010 to the factory default setting:

1) Press and hold the Reset button-hole for more than 3 seconds and then release it

(The device must be plugged into electrical socket - The WLAN/WPS LED

indicator will flash red and orange)

2) After 30 seconds, the WLAN/WPS LED indicator will flash green.

3) Unplug the NHP5010 from the power socket

4) Plug it again.

The NHP5010 has now been restored to the factory default settings.