User manual

ADDON HP2100 User Manual

Set Local Device Only

This button is used to change the network name of the local device. If a new

network name is entered, all the devices appeared in the main panel prior to this

are no longer present in the new network, effectively making the local devices not

to communicate to the devices which are in the old logical network. Click Set Local

Device Only, the devices previously set up with the same logical network (same

network name) appears in the device list.

Set All Devices

This button is used to change the logical network of all devices that appear in the

main panel. If these devices whose passwords have been entered for the same

logical network, a dialog box appears, indicating the success of this operation. For

the devices whose passwords are not entered, this operation will fail and it will

report a failure message.

4.3 Diagnostics Tab

The Diagnostics screen shows the system information and history of all remote

devices appeared over a period of time. See

Figure 7.

The Upper panel shows technical data concerning software and hardware on the

host computer that are used to communicate through HomePlug on the powerline

network. It includes the following:

Operating system platform/version

Host network name

User name

MAC address of all NICs (Network interface card) connected to the host

Identify versions of all driver DLLs and libraries used (NDIS) and optionally

HomePlug chipset manufacturer name (Turbo Only devices)

Firmware version

MAC addresses of all devices connected locally to the host

Version of the configuration utility

Vendor name