User Manual

 
 ________________________________________________________________________________________________________________
45
Figure9.1Setup
9.Setup
To personalize your calibrator, use utilities and get help, etc. you can
pressSetupinBasicModetoentertheSetuppage(asFigure9‐1).
InSetuppage,youcanpressthenavigationkeystomovethecursorand
pressEnterortheSelecttochoosethesubitem.
Thefollowing
sectionswillintroduceyoutouseSetup.
9.1 RS-232 Interface
Inordertoconnectthecalibra tortoanRS‐232serialportonapersonal
computer, be sure to select the correct Address and Baud rate. The 
addressistheuniqueidentificationofacalibrator,itisthenumericallabel
assigned to each device that
uses the serial port protocol for
communication.
9.2 Snapshot Management
Forthiscalibrator,asnapshotisthestateofthesystematanyparticular
timepoint.
You can have a paperlessrecord by using the snapshot function at any
time. Press Savein Basic Mode, the calibrator will take a snapshot and
add it to
 the memory. A snapshot includes: snapshotname, measuring