User Manual

 
 ________________________________________________________________________________________________________________
44
Detector)typesbycalibratorsupported.
ProceedasfollowstosimulateanRTD:
1. Ifsourceisactive,press  once,otherwisepress twice.
2. PressthenavigationkeysUp/Downtoselecttheseconditeminthepop‐uplists,andthenpressEnterorDoneto
switchsourcetoRTDsimulationorpress
OptionstoshowRTDsimulationsetupinterface.InRTDsimulationsetup
interface,youcansettheRTDsensortypeandtemperatureunits(,K, )℃℉.
3. In RTD simulating, you can press Options to show RTD simulation setup int erface and set the simulation
parameters.
4. Refer tothesections
8.3.1,8.3.2,8.3.4or8.3.5to selectamethodtochangethesourcevalue accordingtoyour
need.
8.4 Capture the snapshot
InBasicMode,youcanpressSavetocaptureasnapshot.Whenthesnapshotissuccessfullysavedtothememory,the
calibrator will display the save icon in the status bar and beep at the
same time. For more details about snapshot
pleaserefertosection9.2SnapshotManagement.