User Manual

 
 ________________________________________________________________________________________________________________
41
5. Ifyouwanttostopsourcing,pressStop,andthesoftkeylabelwillchangebacktoStart,youcanresumesourcing
pulsetoo.
8.3.10 Resistance Simulation
Proceedasfollowstosimulateresistance:
1. If source is active, press once, other wise press
twice.
2. PressUp/Downtoselectthefirstitem(range1to
400Ω)or
seconditem(r ange1to4000Ω)fromthepop‐uplists,and
then press Enter or the Done to change the source to
resistancesimulation.
3. Refer to the sections 8.3.1, 8.3.2, 8.3.3, 8.3.4 or 8.3.5,
select a method to change the source value according to
yourneed.
8.3.11 Current Source
Proceedasfollowstosourcecurrent:
1. Figure8.15showsthecurrentsourceconnections.
2. If source is active, press once, otherwise press
twice.
3. PressthenavigationkeysUp/Downtoselectthefirstitem
(internal 24V DC loop power) or seconditem(externpower) from the pop‐up
 list, then pressEnter or Done to

Figure8.15CurrentSource