User Manual

 
 ________________________________________________________________________________________________________________
40
application
8.3.8 Frequency Source
Proceedasfollowstosourcefrequency:
1. Ifsourceisactive,press  once,otherwisepress twice.
2. Press the navigation keys Up/Down to select the third item from the pop‐up list, then press Enter or Done to
changethesourcetofrequencyorpresstheOptionssoftkeyto
showthefrequencysourcesetupinterface.Inthe
frequencysourcesetupinterface;youcansettheamplitude.
3. When frequency sourcing, you can press Options to view frequency source setup interface and set the source
parameters.
4. Refer tothesections8.3.1, 8.3.2,8.3.3or8.3.4toselectamethodtochange
thesourcevalueaccordingtoyour
need.
8.3.9 Pulse Source
Proceedasfollowstosourcepulse:
1. Ifsourceisactive,press  once,otherwisepress twice.
2. PressthenavigationkeysUp/Downtoselectthefourthitemfromthepop‐uplist,andthenpressEnterorDoneto
changethesourcetopulse
orpressOptionstoshowpulsesourcesetupinterf ace.Inpulsesourcesetupinterface,
youcansetthetriggeringedgemode,amplitudeandfrequency.
3. Inpulsesourcing,youcanpressOptionstoshowpulsesourcesetupinterfaceandsetthesourceparameters.
4. Refertothesections8.3.1or8.3.2
toselectamethodtochangethesourcevalueaccordingtoyourneed, tostart
sourcingpulse,youmustpressStartandthesoftkeylabelwillchangetoStop.