User Manual

 
 ________________________________________________________________________________________________________________
39
 RunMode(RepeatorSingleshot)
3. Tocompletetherampsettings,pressEnterorDone,thenthecalibratorwillreturntotheBasicModeandshowthe
mainscreen.
4. PressEnterorStarttobeginautomaticramping,andthesoftkeylabelwillchangetoPause.
5. Press Pause to pause
 automatic ramping, and the softkey label will change to Resumeat the same time.Press
Resumeresumingtheautomaticramping.
Ifyouwanttoexitautomaticramping,pressEscorExit.
8.3.6 Millivolts Source
Proceedasfollowstosourcemillivolts:
1. Ifsourceisactive,press  once,otherwisepress twice.
2. YoucanPressthe
navigationkeysUp/Down toselectthefirstitemfromthepop‐uplist,thenpressEnterorDone
tochangethesourcetomillivolts.
3. Refer to the section8.3.1, 8.3.2, 8.3.3, 8.3.4 or 8.3.5, select a method to change the source value that fit your
application.
8.3.7 Volts Source
Proceedasfollowstosource
volts:
1. Ifsourceisactive,press  once,otherwisepress twice.
2. Press the navigation keys Up/Down to selectthe second item from the pop‐up list, then press Enter orDone to
changethesourcetovolts.
3. Refer to the sections 8.3.1,8.3.2, 8.3.3, 8.3.4or 8.3.5,selecta
method to change thesourcevalue that fit your