User Manual

 
 ________________________________________________________________________________________________________________
35

Figure8.12SteppingResults
Steppingsupportsthreemodes:anengineeringunit,scaleandsteppoints.
Note:
Intheengineeringunitandsteppingmode,thetransferfunctionsdefaultsettingisalwayslinear.
Onlyforautostep,therunmodeandsteptimearevalid.TherangeoftheSteptimeis1to3600seconds.
To use manual stepping, proceed as follows:
1.
Ifnecessary,pressthenavigationkeysUp/Downuntilsourceis active.
2. PressSteptoshowthestepsetupinterface,andconfiguretheseparametersasfollows:
 StartValue(inunits)