User Manual

 
 ________________________________________________________________________________________________________________
34
Figure8.11SteppingConfiguration
Toexitfinetuning,youcanpressEscorEnterkey .
Notes:
If there is no operation within 15 seconds, the calibrator will exit fine
tuningautomatically.
Youcannotchangethefinetuningifthesourcevalueexceedstheoutput
range,thecalibratorwillbeep.
8.3.3 Reset the source value
IntheBasicMode, forvolts,millivolts,
frequency,resistanceandcurrent
sourceitems,thecalibratorofferstheresetfunction.PressResetsoftkey,
andthesourcevaluewillbesettozeroimmediat ely.
8.3.4 Stepping the source value
In Basic Mode, the calibrator supports stepping the source value
manually or automatically. Before Stepping, you will need to configure
thestepsettings.Eachsourceitem
hasitsownstepsettings.Whenthe
source is active and source item is not pulse and pressure, you can
pressStepto view the step setup interface. Figure 8.11 and Figure 8.12
areexamplesofStepsettingsandthestepresultsofsettings.
StartvaluecannotbethesameastheEnd
value,andtheirvaluescannot
exceedthelimitedsouringrange.Asteppingcycleisfr omstartvalueto
endvalue,andafollowingcycleisfromendvaluetostartvalue.