Owner's manual

Addictive Desert Designs

1999 – 2014 ford superduty and

Excursion Stealth Side steps

installation instructions

PREPARATION STEPS

1. Set emergency brake.

2. You will need the following tools:

a. 13 mm socket

b. ratchet or air gun

c. Regular standard screw driver

Note: This installation requires 2 people for best results

3. Included in Kit:

a. Right Side Step(1)

b. Left Side Step(1)

c. Hardware

PAGE 1
Addictive Desert Designs 1999 – 2014 ford superduty and Excursion Stealth Side steps installation instructions PREPARATION STEPS 1. Set emergency brake. 2. You will need the following tools: a. 13 mm socket b. ratchet or air gun c. Regular standard screw driver Note: This installation requires 2 people for best results 3. Included in Kit: a. Right Side Step(1) b. Left Side Step(1) c.
PAGE 2
INSTALLATION INSTRUCTIONS 1. Remove stock side steps if they are present. 2. Relocate nut clips from front set to the next set back. 3. Remove all nut clips from bottom holes. 4. Install new steps, line all bolt holes up, and use stock bolts for all upper holes. 5. Use Allen head bolts, nuts, and washers on lower bolt holes. 6. Tighten all bolts.
PAGE 3
7. To finish your side step installation you will now have to locate the dome light circuit for your vehicle and wire a positive from the LED strip to your circuit. Then you will need to run a ground wire to your chassis. This should complete your installation. Now step back and enjoy your ADD Stealth side steps. For additional support or technical questions, please call 480.671.0820 or email info@addictivedesertdesigns.com Addictive Desert Designs 4840 E. Jasmine Street Suite 112 Mesa, AZ 85205 www.