Phau Ntawv Qhia

10
INSTALLATIONCONFIGURATIONOPERATION
FURTHER
INFORMATION
INDEX
CONNECTIONS
Connections to the AdderLink XD522 units do not need to be carried out in the order
given within this guide, however, where possible connect the power in as a nal step.
Transmitter
Video connections
Video connections are made between the host computer and the two DisplayPort
sockets on the rear panel of the transmitter unit.
To connect the video ports
1 Use the supplied DisplayPort video cable to link DP port 1 on the rear panel of the
transmitter unit with the primary video output socket of the host computer.
From the host
computer’s
secondary
DisplayPort
video output
From the host
computer’s
primary
DisplayPort
video output
2 If a second video display is required, use an additional DisplayPort video cable (Adder
part number: VSCD18) to link DP port 2 on the rear panel of the transmitter unit
with the secondary video output socket of the host computer.
USB connections
USB connections are made between the host computer and the two sockets on the rear
panel of the transmitter unit, labeled Link A and Link B.
Link A provides low/full speed USB to the three USB ports (all labeled A) that are
located on the front panel of the AdderLink XD522 receiver. The optional Link B
provides Hi-Speed USB to the single USB port (labeled B) that is also located on the
front panel of the AdderLink XD522 receiver.
From USB sockets on
the host computer
Note: Low/full speed USB devices can also be used on port B; the transfer speed will be
automatically reduced. The A ports support USB keyboards and mice only.
To connect the USB ports
1 Use one of the supplied USB cables to connect the Link A socket on the rear panel of
the transmitter unit with a vacant USB socket on the host computer.
2 If the USB port B is required (on the receiver unit), use the second supplied USB cable
to connect the Link B socket on the rear panel of the transmitter unit with a vacant
USB socket (v2.0) on the host computer.