User guide

Page | 13
ePowerSwitch 8XS
6.3.2. Reading out the power outlet status
This command enables to read out the status of each power outlet.
Command to be sent to the ePowerSwitch 8XS:
Rxy[CR]
Reply from the ePowerSwitch 8XS:
Rxy=z[CR]
Explanations:
Parameter Value Function/Remark
x address of the ePowerSwitch 1 to 16 specifies the address of the ePowerSwitch 8XS
y number of the Power Outlet 1 to 8 specify the number of the power outlet
z status
0 status of the corresponding power outlet is OFF
1 status of the corresponding power outlet is ON
Examples:
R11[CR] Read status of the power outlets #1 of ePowerSwitch #1
R168[CR] Read status of the power outlets #8 of ePowerSwitch #16
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by
the character [CR].