User guide

Page | 9
ePowerSwitch 8XS
2. Allocate an address to each Satellite by positioning the address selection DIP-switches marked "Slct"
on the front panel according to the following table.
Remarks
− Unplug the power cords of the ePowerSwitch 8XS before changing its DIP switches.
− Do NOT use the same address for two different Satellites.
Satellite
Address
DIP-Switch
1
DIP-Switch
2
DIP-Switch
3
DIP-Switch
4
1 Off Off Off Off
2 [ON] Off Off Off
3 Off [ON] Off Off
4 [ON] [ON] Off Off
5 Off Off [ON] Off
6 [ON] Off [ON] Off
7 Off [ON] [ON] Off
8 [ON] [ON] [ON] Off
9 Off Off Off [ON]
10 [ON] Off Off [ON]
11 Off [ON] Off [ON]
12 [ON] [ON] Off [ON]
13 Off Off [ON] [ON]
14 [ON] Off [ON] [ON]
15 Off [ON] [ON] [ON]
16 [ON] [ON] [ON] [ON]
3. On both devices located at the end of the xBus, switch the DIP-Switch 5 and 6 to ON to activate
the built-in termination resistors.
4. Plug the 2 power cables into 2 grounded
sockets. The A and B LEDs light on to confirm that power is
on.
Position Off = switch upwards,
Position On = switch downwards
DIP-Switch 1 is located on the left side
DIP-Switch 5 and 6 are used to activate
the built-in termination resistors.