Technical data

63
Send Syslog Messages:
This type of action appears and can be configured only if you have already created at least one
destination Syslog Server (Misc/Log Settings Tab).
Check this box if you want to send a message to a Syslog server. In the following drop-down lists choose
the facility and the severity of the message to send. The address of the Syslog server has to be defined in
the "Log Settings Page".
Send Trap Message:
This type of action appears and can be configured only if you have already specified at least a
destination SNMP Server (General/SNMP Tab).
Check this/these box(es) and specify one or two SNMP addresses in the corresponding field if you want to
send SNMP messages to one or two SNMP Servers.
Mail to:
This type of action appears and can be configured only if you have already created a destination
SMTP Server (General/SMTP Tab).
Check this/these box(es) and specify one or two e-mail address(es) in the corresponding field if you want
to send an e-mail to one or two specific user(s). To send e-mails, you will need a SMTP server on the
network and you will have to configure its parameters in the "SMTP Page".
Syslog / Trap / Mail Message:
This field appears only if you have already specified at least one destination Syslog Server
(Misc/Log Settings Page), one destination SNMP Server (General/SNMP Page) or a destination
SMTP Server (General/SMTP Page).
Up to 255 characters may be entered in this free text field. The text will appear in the Syslog, the Trap and
the e-mails.
The message can be completed with the status of an input (a power supply or door contact for example)
or the value of a sensor (a temperature sensor for example). For this, simply enter, between two percent
characters, the ID of the corresponding input device (for details see § 5.1 Sending status and values using
rules).
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.