Technical data

29
Name:
In this field, enter the name you want to give to the selected ePowerSwitch. The name can be from 1 to 32
characters long and can contain alphanumeric characters.
Analog Inputs:
Only for Satellite 8XS /32
Name:
In this field, enter the name you want to give to the two current inputs A and B. The name can be from 1 to
32 characters long and can contain alphanumeric characters.
Unit:
In this field enter the unit of measurement you want to be displayed.
Graph:
Check this box if you want a display of the analog inputs.
Period (minutes):
In this field enter the period between two measurements.
Power Supplies:
In this field, enter the name you want to give to the two power input A or B. The name can be from 1 to 32
characters long and can contain alphanumeric characters.
Power Outlets:
In this field, enter the name you want to give to each power outlet of the ePowerSwitch Satellite. The
name can be from 1 to 32 characters long and can contain alphanumeric characters.
Default Power-Up:
In the drop-down lists, choose for each power outlet the default status to apply after power-up.
You can choose between:
- "On" if you want the corresponding power outlet to be always switched On after power-up.
- "Off" if you want the corresponding power outlet to be always switched Off after power-up.
- "Last Status" if you want that the corresponding power outlet takes again the state it was in before power
failure.
Power up delay:
In this field, enter the power up delay you want to define for each power outlet. Power up delay means the
delay before the power outlet will take the defined status after power up. The delay can be set between 1
and 65535 seconds, the value 0 means that no delay has to be applied after power up.
Function delay:
In this field, enter the delay you want to define before the execution of a function (for example Restart
function of an outlet).
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.