Technical data

25
ID:
The ePowerSwitch 8XM automatically creates an ID Code to clearly identify each device and each input.
• M0 identifies the ePowerSwitch 8XM device,
• PW followed by "A", "B" or "X" identifies power supply input A, B and auxiliary power input,
• DI followed by 1 to 8 identifies the Digital Inputs of the I/O Extension Module (option),
• EM identifies the I/O Extension Module (option),
• O followed by 1 to 8 identifies the power outlets.
Name:
In these fields, enter the name you want to give to the selected device, its power outlets, digital inputs or
outputs and power supplies. The name can be from 1 to 32 characters long, and can contain
alphanumeric characters.
Power Supplies:
In this field, enter the name you want to give to the two power inputs A and B and to the auxiliary power
input. The name can be from 1 to 32 characters long and can contain alphanumeric characters.
Digital inputs:
In this field, enter the name you want to give to each Digital Input of the I/O Extension Module connected
to the ePowerSwitch (option). The name can be from 1 to 32 characters long and can contain
alphanumeric characters.
Power Outlets:
In this field, enter the name you want to give to each power outlet of the ePowerSwitch. The name can be
from 1 to 32 characters long and can contain alphanumeric characters.
Default Power-Up:
In the drop-down lists, choose for each power outlet the default status to apply after power-up.
You can choose between:
- "On" if you want the corresponding power outlet to be always switched On after power-up.
- "Off" if you want the corresponding power outlet to be always switched Off after power-up.
- "Last Status" if you want that the corresponding power outlet takes again the state it was in before power
failure.
Power up delay:
In this field, enter the power up delay you want to define for each power outlet. Power up delay means the
delay before the power outlet will take the defined status after power up. The delay can be set between 1
and 65535 seconds, the value 0 means that no delay has to be applied after power up.
Function delay:
In this field, enter the delay you want to define before the execution of a function (for example Restart
function of an outlet).
Digital outputs:
In this field, enter the name you want to give to each Digital Output of the I/O Extension Module connected
to the ePowerSwitch (option). The name can be from 1 to 32 characters long and can contain
alphanumeric characters.
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.