Technical data

CHAPTER 8: Controlling the Power Outlets of the Satellites using a Terminal Connection
8.3.5 Setting the Restart Delays
This command enables to set the Restart Delay individually for each Power Outlet. The Delay value can be
between 1 and 255 seconds (4 min 15 sec).
Command to be sent to the ePowerSwitch 8XS:
TRxy=z[CR]
Reply from the ePowerSwitch 8XS:
TRxy=z[CR]
Explanations:
Parameter Value Function/Remark
x address of the ePowerSwitch 1 to 16 specifies the address of the ePowerSwitch 8XS
y number of the Power Outlet 1 to 8 specifies the number of the Power Outlet
z timer value 1 to 255 set the Restart Delay (in sec)
Examples:
TR31=17 Set Restart Delay of the Power Outlet #1 of ePowerSwitch #3 to 17 sec
Remarks:
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by the
character [CR].
8.3.6 Reading out of the Restart Delays
This command enables to read out the Restart Delay individually for each Power Outlet.
Command to be sent to the ePowerSwitch 8XS:
TRxy[CR]
Reply from the ePowerSwitch 8XS:
TRxy=z[CR]
Explanations:
Parameter Value Function/Remark
x address of the ePowerSwitch 1 to 16 specifies the address of the ePowerSwitch 8XS
y number of the Power Outlet 1 to 8 specifies the number of the Power Outlet
z timer value 1 to 255 shows the Restart Delay (in sec)
Remarks:
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by the
character [CR].
50