Technical data

ePowerSwitch 8XM / 8XS
8.3.3 Setting of the Power Up Delays
This command enables to set the Power Up Delay individually for each Power Outlet. The Delay value can
be between 1 and 255 seconds (4 min 15 sec).
Command to be sent to the ePowerSwitch 8XS:
TUxy=z[CR]
Reply from the ePowerSwitch 8XS:
TUxy=z[CR]
Explanations:
Parameter Value Function/Remark
x address of the ePowerSwitch 1 to 16 specifies the number of the ePowerSwitch 8XS
y number of the Power Outlet 1 to 8 specifies the number of the Power Outlet
z timer value 1 to 255 set the Power Up Delay (in sec)
Examples:
TU12=2 Set Power Up Delay of the Power Outlet #2 of ePowerSwitch #1 to 2 sec
T163=10 Set Power Up Delay of the Power Outlet #3 of ePowerSwitch #16 to 10 sec
Remarks:
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by the
character [CR].
8.3.4 Reading out of the Power Up Delay(s)
This command enables to read out the Power Up Delay individually for each Power Outlet.
Command to be sent to the ePowerSwitch 8XS:
TUxy[CR]
Reply from the ePowerSwitch 8XS:
TUxy=z[CR]
Explanations:
Parameter Value Function/Remark
x address of the ePowerSwitch 1 to 16 specifies the number of the ePowerSwitch 8XS
y number of the Power Outlet 1 to 8 specifies the number of the Power Outlet
z timer value 1 to 255 shows the Power Up Delay (in sec)
Remarks:
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by the
character [CR].
49