Manualshelf

Technical data

ManualsBrandsADDER ManualsComputer equipmentePowerSwitch 8XS
41424344454647484950
CHAPTER 8: Controlling the Power Outlets of the Satellites using a Terminal Connection
8.3.2 Reading out the Power Outlet Status
This command enables to read out the status of each Power Outlet.
Command to be sent to the ePowerSwitch 8XS:
Rxy[CR]
Reply from the ePowerSwitch 8XS:
Rxy=z[CR]
Explanations:
Parameter Value Function/Remark
x
address of the ePowerSwitch 1 to 16 specifies the address of the ePowerSwitch 8XS
y
number of the Power Outlet 1 to 8 specify the number of the Power Outlet
0 status of the corresponding Power Outlet is OFF z status
1 status of the corresponding Power Outlet is ON
Examples:
R11[CR] Read Status of the Power Outlets #1 of ePowerSwitch #1
R168[CR] Read Status of the Power Outlets #8 of ePowerSwitch #16
Remarks:
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by the
character [CR].
48