Technical data

ePowerSwitch 8XM / 8XS
7. Installation the ePowerSwitch 8XS
Remark:
Make sure that all the ePowerSwitch devices are powered off.
Connection Instructions
1. Connect the supplied RJ11 link-up cable to one of the x Bus connector of the ePowerSwitch 8XM and to
one of the xBus connector of the ePowerSwitch 8XS.
To cascade several Satellites, link the second xBus connector of a Satellite with one of the x Bus
connector of the next Satellite.
2 3 4
DC
DRY CONTACTS
MAX 24VDC - 20mA
12VDC AUX
POWER SUPPLY
I/O
A 1 2 3 4
10/100
Link 100
RS232 x Bus Te rm
S B 5 6 7 8 1
RS232Slct
Te rm
86 7
x Bus
3 4 5
Power
2B 1A
RS232Slct
Te rm
86 7
x Bus
3 4 5
Power
2B 1A
2. Allocate an address to each Satellite by positioning the address selection DIP-switches marked "Slct" on
the front panel according to the following table.
Remarks
− Unplug the power cords of the ePowerSwitch 8XS before changing its DIP switches.
− Do NOT use the same address for two different Satellites.
Satellite
Address
DIP-Switch
1
DIP-Switch
2
DIP-Switch
3
DIP-Switch
4
1 Off Off Off Off
2 [ON] Off Off Off
3 Off [ON] Off Off
4 [ON] [ON] Off Off
5 Off Off [ON] Off
6 [ON] Off [ON] Off
7 Off [ON] [ON] Off
8 [ON] [ON] [ON] Off
9 Off Off Off [ON]
10 [ON] Off Off [ON]
11 Off [ON] Off [ON]
12 [ON] [ON] Off [ON]
13 Off Off [ON] [ON]
14 [ON] Off [ON] [ON]
15 Off [ON] [ON] [ON]
16 [ON] [ON] [ON] [ON]
Position Off = switch upwards,
Position On = switch downwards
DIP-Switch 1 is located on the left
side
3. Plug the 2 power cables into 2 grounded sockets. The A and B LEDs light on to confirm that power is on.
45