Technical data

ePowerSwitch 8XM / 8XS
5.3.18 Misc / Log Settings Page
ePowerSwitch 8XM can output Syslog messages and/or send selected logs to a specific e-mail address. The
logs are often quite useful for discovering the causes of tricky problems.
For the logs to be sent to a specific e-mail address, the administrator can choose the severity of the
messages to be sent.
Syslog Server Address
If you want to enable the ePowerSwitch 8XM to send messages to a Syslog Server, check the box "Syslog
Server Address" and enter the address of the Syslog Server you wish to use.
You can enter either the hostname or the IP address of a Syslog server.
ePowerSwitch 8XM uses the usual UDP Port 514 to output Syslog messages.
Example: syslog.ePowerSwitch.com or 192.168.1.252
E-Mail Address
If you want to enable the ePowerSwitch 8XM to send e-mails, check the box "e-mail address" and specify the
destination e-mail address to be used.
Type of messages to sendSeverity of the messages to be sent
Specify in this field the severity of the messages you want to send to the specified e-mail address. The
messages are classified in 8 severity Levels (see Syslog Messages: Severity Level Definition).
LOGOUT
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES
Click "Apply Changes" at the bottom of the page to save changes.
43