Technical data

CHAPTER 5: Configuring the ePowerSwitch 8XM
Action Condition
The options "higher than" and "lower than" enables you to define when the rule has to be executed.
- Choose "higher than" if you want to execute the rule if the environment value exceeds the value you
defined in the field on the right of "higher than".
- Choose "lower than" if you want to execute the rule if the environment value is below the value you defined
in the field on the right of "lower than".
For temperature, you can define values between xx° and yy °C
For relative humidity, you can define values between xx RH and yy RH
Set Power Outlet
Check this box and in the corresponding drop-down list, choose the power outlet the rule will apply to. In the
next corresponding drop-down list, choose the action to execute. Each power outlet can be switched On/Off
and restarted. If you choose "restart" you will also be able to define a restart delay between 0 and 65535
seconds.
Set Group
!!! This type of action is only possible if you already created at least one group.
Check this box and in the corresponding drop-down list, choose the power outlet group the rule will apply to.
In the next corresponding drop-down list, choose the action to perform.
Each power outlet group can be switched On/Off and restarted. If you choose "restart" you will also be able
to define a restart delay between 0 and 65535 seconds.
- If you choose 0 second for the delay, the delay will be the delay defined in the "Power Outlets Page".
- If you choose a delay different from 0, the delay will replace the delay defined in the "Power Outlets Page".
Set Dry Contact
Check this box and in the corresponding drop-down list, choose the dry contact the rule will apply to. In the
next corresponding drop-down list, choose the action to execute.
Each power dry contact can be switched On/Off and pulsed (open or close) for a specified delay. The delay
can be define between 0 and 65535 seconds.
Send Syslog Messages
Check this box if you want to send a message to a Syslog server. In the following drop-down lists, choose
the facility and the severity of the message to send.
The address of the Syslog server has to be defined in the "Log Settings Page".
Mail to
Check this box and specify an e-mails address in the corresponding field if you want to send an e-Mail to a
specific user. To send e-mails, you will need a SMTP server on the network and you will have to configure its
parameters in the "SMTP Page".
LOGOUT
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES
Click "Apply Changes" at the bottom of the page to save changes.
40