Technical data

CHAPTER 5: Configuring the ePowerSwitch 8XM
5.3.3 General / SMTP Page
The ePowerSwitch 8XM can be configured to send e-mails to addresses specified in the Settings/Rules Tab.
To send e-mails, you will need a SMTP server on the network and you will have to configure the following
parameters:
SMTP enabled
Check this box if you want the ePowerSwitch 8XM to be able to send e-mails.
SMTP Server Address
In this field, enter the address of the e-mail server you want to use.
You can enter either the hostname or the IP address of a NTP server.
Example: smtp.yahoo.com or 127.0.0.1
SMTP Port
In this field, enter the Port Number you want to use, default and usual value is 25.
From Address
In this field, enter the E-Mail address that ePowerSwitch 8XM messages will appear to come from. This
should be a valid address (generally servers rejects messages that don't have a valid from address).
LOGOUT
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES
Click "Apply Changes" at the bottom of the page to save changes.
20