Technical data

CHAPTER 4: Installation the ePowerSwitch 8XM
4. Installation the ePowerSwitch 8XM
Remark:
Make sure that the ePowerSwitch 8XM is powered off.
Connection Instructions
1. Use a shielded
RJ45 Network Cable to connect your ePowerSwitch 8XM to the network.
2. Use appropriated three-wire Power Cords (two poles plus ground) to connect your electrical devices to
the ePowerSwitch 8XM unit.
3. Plug the 2 power cables into 2 grounded sockets. The Power Supply LED of group A and of group B light
on to confirm that power is on.
4. You can now configure the ePowerSwitch 8XM by following the indications of the chapter "Configuration
of the ePowerSwitch 8XM" or, if necessary, install the ePowerSwitch 8XS as indicated hereafter.
12