Specifications

 


11
g
 SettheOPTIONSportbaudrate
 1200
 2400
 9600
 19200
 38400
 57600
 115200
 EntertheFunctions menu
Show current firmware version
 Resetcongurationtofactorydefaults( is displayed momentarily)
 EntertheHotkey menu
Ctrl + Alt
Ctrl + Shift
Alt + Shift
 RightAlt
Alt
Left Ctrl + Alt
 RightCtrl+Alt
Hotkeys disabled
Set a new password for use with the lock mode
 EntertheSwitch Mode menu
All
 K/M+Speaker
 K/Monly
Speaker only
 USB1only
 USB2only
 EntertheUser Preferences menu
 Enablemouseswitching
 Disablemouseswitching
Cycle all ports (when using ‘Hotkey + Tab’ or ‘Autoscan’)
Cycle only active ports (when using ‘Hotkey + Tab’ or ‘Autoscan’)
You can press
at any point to exit
from an option and
return to the main
menu ( ) section.
Configuration
Using the configuration menu
The configuration mode allows you to determine numerous aspects of the
CCS4-USB unit capabilities.
To use the configuration menu
Duringnormaluse,thesevensegmentdisplayonthecontrolpanelshowsthe
number of the currently selected computer channel. From this condition, enter
configuration mode as follows:
1 PressandholdthecontrolpanelCOMPUTER button for roughly five seconds.
The display will show:
2 Onthekeyboard,presstheletterkeyfortherequiredmenusection,e.g.
The display will show the pressed letter, e.g.
3 Pressthenumberoftherequiredsetting,e.g.
The display will show the pressed number, e.g.
4 Press to accept the setting and return to the main menu section.
The display will show:
5 Youcannowcontinuewithyournextcongurationchange(gotostep2),
or exit from the configuration menu (see below).
To exit the configuration menu and save changes
• Press and then press to exit and save changes.
To exit the configuration menu without saving
• Presseitherofthefrontpanelbuttons.
SECT3