Specifications

 


10
g
Switching control by computer
The OPTIONS port allows an external serial input, typically from a computer, to
control the selection of the various channels. You can use either the supplied
FlashUpgradeAdaptorplusastandardCAT5patchcable(partnumberVSC23)
or alternatively construct a custom cable to link the CCS4-USB unit and the
computer. For pin-out details of the custom cable, see Appendix 1.
Upon receipt of the correct code, the CCS4-USB will switch immediately to the
appropriate channel.
Connecting a computer for remote control
Thecablelinkfromthecomputerneedstoconnectthetransmit(TXD)lineof
thecomputertothereceive(RXD)inputoftheCCS4-USBandalsolinkthe
groundterminals(GND)ofthetwodevices.SeeAppendix 1 for details.
To connect a computer remote control
1 UseeitherthesuppliedFlashUpgradeAdaptorplusastandardCAT5patch
cable or alternatively a custom cable to link the OPTIONS port on the rear
panel of the CCS4-USB unit and a vacant serial port on the computer.
Serial port parameter settings
Ensurethatthechosenserialportisconguredtothefollowing:
• Baudrate: 1200
• Databits: 8
• Stopbit: 1
• Parity:  None
Channel selection codes
ASCII
Character Hex Decimal
• Channel1: ‘1’ 0x31 49
• Channel2: ‘2’ 0x32 50
• Channel3: ‘3’ 0x33 51
• Channel4: ‘4’ 0x34 52
5V
2.5A
I N D O O R
U S E
O N LY
OPTIONS