Specifications

 


14
g
Set the OPTIONS port baud rate
 1200
 2400
 9600
 19200
38400
57600
 115200
 EntertheFunctions menu
Show current firmware version
Reset configuration to factory defaults ( is displayed momentarily)
 EntertheHotkey menu
Ctrl + Alt
Ctrl + Shift
Alt + Shift
Right Alt
Alt
Left Ctrl + Alt
Right Ctrl + Alt
Hotkeys disabled
Set a new password for use with the lock mode
 EntertheSwitch Mode menu
All
 K/M+Speaker
 K/Monly
Speaker only
 USB1only
 USB2only
 EntertheUser Preferences menu
 Enablemouseswitching
Disable mouse switching
Cycle all ports (when using ‘Hotkey + Tab’ or ‘Autoscan’)
Cycle only active ports (when using ‘Hotkey + Tab’ or ‘Autoscan’)
You can press
at any point to exit
from an option and
return to the main
menu ( ) section.
Configuration
Using the configuration menu
The configuration mode allows you to determine numerous aspects of the
CCS4-USB switch capabilities.
To use the configuration menu
During normal use, the seven segment display on the control panel shows the
number of the currently selected computer channel. From this condition, enter
configuration mode as follows:
1 PressandholdthecontrolpanelCOMPUTER button for roughly six seconds.
The display will show:
2 Onthekeyboard,presstheletterkeyfortherequiredmenusection,e.g.
The display will show the pressed letter, e.g.
3 Press the number of the required setting, e.g.
The display will show the pressed number, e.g.
4 Press to accept the setting and return to the main menu section.
The display will show:
5 Youcannowcontinuewithyournextcongurationchange(gotostep2),
or exit from the configuration menu (see below).
To exit the configuration menu and save changes
• Press and then press to exit and save changes.
To exit the configuration menu without saving
• Presseitherofthefrontpanelbuttons.
SECT3