User guide

 




14
General configuration
Changing hotkeys
AV4PRO-DVI units use and as their standard hotkeys. These can be
changed if they clash with other software or hardware within the installation.
To change the hotkeys
1 Enter the Configuration menu.
2 Press to enter the Hotkey menu and then press either:
to choose Ctrl + Alt
to choose Ctrl + Shift
to choose Alt + Shift
to choose Right Alt
3 Press to accept the setting and return to the main menu section.
4 Press
and then to exit the menu and save changes.
Mouse switching
You can enable or disable mouse switching to suit your installation requirements.
To enable/disable mouse switching
1 Enter the Configuration menu.
2 Press to enter the User Preferences menu and then press either:
to Enable mouse switching
to Disable mouse switching
3 Press to accept the setting and return to the main menu section.
4 Press and then to exit the menu and save changes.
OPTIONS port speed
You can change the speed of the OPTIONS serial port.
To change the OPTIONS port speed
1 Enter the Configuration menu.
2 Press to enter the Baud rate menu and then press either:
to choose 1200
to choose 2400
to choose 9600
to choose 19200
3 Press to accept the setting and return to the main menu section.
4 Press and then to exit the menu and save changes.
OPTIONS port channel control behaviour
You can determine how the OPTIONS port responds to channel control inputs.
To define the OPTIONS port behaviour
1 Enter the Configuration menu.
2 Press to enter the Options port menu and then press either:
toallowchannelswitchingcommandstobereceivedviaRS-232serial
signal through the OPTIONS port (see Appendix 2 for cable pin-out
details and Channel switching by external control for command
details). The baud rate currently set by the option will be used for the
port. Switching commands via the four channel select inputs within the
OPTIONS port connector are disabled in this mode. Use option if you
wishtoenablethechannelselectinputsinadditiontoRS-232control.
to allow channel switching commands to be received from the optional
RC4remotecontrol(seeOptional RC4 control for connection details).
The baud rate set by the option is ignored and the rate used by the
RC4isautomaticallyimposed.Switchingcommandsviathefourchannel
select inputs within the OPTIONS port connector are disabled in this mode.
enableschannelswitchingviaRS-232asperoption . However, in this
mode the four channel select inputs are also enabled.
3 Press to accept the setting and return to the main menu section.
4 Press and then to exit the menu and save changes.
continued
to choose Alt
to choose Left Ctrl + Alt
to choose Right Ctrl + Alt
to disable the Hotkeys
to choose 38400
to choose 57600
to choose 115200